![]() MSI RTX 2070 Super Gaming X Trio / Intel HD620 Noctua NH-U12A 2 fans + Thermal Grizzly Kryonaut Extreme + 5 case fans / Fanģ2GB DDR5 Corsair Dominator Platinum RGB 6000MHz C元6 / 8GB DDR4 HyperX CL13 Gigabyte Z690 Aorus Master / HP 83A3 (U3E1) I've tried loosening the CPU block, tightening. Originally I did have an EK block on, so when I installed the Bykski block I re-did the thermal paste obviously, switched to Thermal Grizzly Kryonaut Thermal Paste which is what I have on the GPU. Idles around 36ºc, full load stress test 58ºc. Only thing I can think of is that after coming ouit from the GPU it doesn't go through a radiator and it's already hot? my GPU is running great. The way this distro plate works is RESERVOIR > PUMP > GPU > RESERVOIR > CPU > RESERVOIR > TOP RAD > FRONT RAD > RESERVOIR > PUMP and so forth. CPU doesn't throttle, but should it not be running cooler than this under water? So idle is about 45ºc then if I put it under 100% (Prime 95 Small FFT's) it goes straight to 90ºc and stays there. the GPU is in the loop, it's a 3090Ti but my understanding is this should be enough cooling for both. It's cooled by an Bykski CPU block, to a Bykski distro plate with two EK S360 rads. Now I won't compare it to my 5600X as that was a Ryzen 5, this is a Ryzen 7, so more cores, etc. ![]() My understanding is that this chip due to the v-cache design runs a bit hotter than a 5800X per say. I recently upgraded my 5600X to a 5800X3D. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |